How To Properly Apply Thermal Grease?

Thermal Grease is a material widely used in electronic equipment. Its main function is to enhance heat dissipation efficiency and prevent electronic components from being damaged due to overheating. Proper application of Thermal Grease can significantly improve the stability and life of your equipment.

What is Thermal Grease?

Thermal Grease is a material that plays an important role in electronic heat dissipation. It is usually mixed with silicone oil and thermally conductive fillers, and has good thermal conductivity and insulation properties.

How to properly apply Thermal Grease?

1. Preparation

Before you begin applying Thermal Grease, make sure all relevant components, such as the processor and heat sink, are clean.

2. Application method

Dot coating method: drop a small dot of thermal grease on the center of the processor.

Application method: Use a plastic scraper or other suitable tool to apply Thermal Grease evenly on the surface of the processor.

Cross method: Apply a thin strip of Thermal Grease to the center of the processor, then lightly apply it in a cross shape.

3. Radiator installation

After applying Thermal Grease, gently place the heat sink over the processor, applying appropriate pressure to ensure good contact.

4. Fix the radiator

Secure the heat sink to the processor using a fixture such as screws or clamps.

Common precautions

Moderate dosage: The dosage of silicone grease should not be too much or too little.

Apply evenly: Make sure the silicone grease is applied evenly without leaving any gaps or air bubbles, this is very important to ensure effective heat transfer.

Periodic Inspections: Inspect regularly and replace when necessary to ensure optimal performance of the system.